2006 Honda TRX680 Rincon Factory Service Manual, Page 552Get this manual
LIGHTSMETERSSWITCHES Install the EOT sensor with new sealing washer and tighten itTORQUE: 12 (1.2 kgf m, Ibfft) Connect the EOT sensor 2P (Black) connectorInstall the removed parts in the reverse order of removalFill the recommended engine oil (page 4-11)2P BLACK CONNECTOR
GPS RECEIVER (GPS model only)
INSPECTION
If the GPS indicator is blinking and the antenna mark and all segments do not indicate at all, check the system by following the troubleshooting "GPS INDICATOR BLINKS" (page 23-17)If the GPS start-up time is too long every time the ignition switch is turned to ON despite of the hot start condition, check the system by following the troubleshooting "GPS START-UP TIME IS TOO LONG" (page 23-18)NOTE: The start-up time of the positioning varies as follows: Hot start When the ignition switch is turned ON within hours after it was turned OFF, the position fix will be completed in about 25 seconds