2006 Honda TRX680 Rincon Factory Service Manual, Page 486Get this manual
REAR DRIVING MECHANISM Pack the inboard joint with 6080 of specified greaseSpecified grease: NKG205 (KYODO YUSHI) Install the inboard joint over the bearingInstall the stopper ring into the groove in the inboard joint properlyInstall the inboard boot over the inboard joint securely
Pack 60Be sure the length of the drive shaft to be set the figure given belowDRIVE SHAFT LENGTH: 425.2 mm (16.74 in)
STOPPER RING
For band Install the shaft boot band and new outboard boot installation direction band onto the outboard boot(page 19-9)Bend down each band end and secure it with the lock tabsTap the lock tabs with plastic hammer