2006 Honda TRX680 Rincon Factory Service Manual, Page 387Get this manual
FRONT WHEELSUSPENSIONSTEERING Assemble the special tools onto the steering shaft bearingRemove the bearing from the frame by tightening the nutTOOLS: Clutch compressor attachment 07LAE-PX40100 Compressor bolt assembly 07GAE-PG40200 or 07GAE-PG4020A (U.S.Aonly) Attachment, 28 30 mm 07946-1870100 10 mm washer Common hardware Draw new bearing into the frame with the marked side facing up until it is fully seatedTOOLS: Clutch compressor attachment 07LAE-PX40100 Compressor bolt assembly 07GAE-PG40200 or 07GAE-PG4020A (U.S.Aonly) Attachment, 42 47 mm 07746-0010300 10 mm washer Common hardware Install the snap ring into the groove properly with the chamfered edge facing upThe upper seal is Coat new dust seal lips with grease and install