2006 Honda TRX680 Rincon Factory Service Manual, Page 308Get this manual
DRIVETRAIN SYSTEM
DRIVETRAIN DTC TROUBLESHOOTING
NOTE: The connector location and the necessary partsto disconnect the connector (page 14-17) Perform inspection with the ignition switch turned OFF, unless otherwise specified After troubleshooting, erase the problem code and test-ride the vehicle to be sure that the system is normal
DTC 3-1 (FRONT FINAL CLUTCH LOW INPUT), DTC 3-3 (FRONT FINAL CLUTCH DRIVE CIRCUIT)
Before starting the troubleshooting, check for loose or poor contact on the front final clutch 2P (Green) connector and PCM 33P (Black) connector and then recheck the DTC1Recheck DTC Turn the ignition switch ON and test-ride the vehicle with 4WD, then recheck the current DTCIs DTC 3-1 or 3-3 indicated? YES NOGO TO STEP 2- Intermittent failure
2Front Final Clutch Inspection Turn the ignition switch OFFDisconnect the front final clutch 2P (Green) connectorMeasure the resistance between the front final' clutch 2P (Green) connector terminals of the clutch sideConnection: OrangeblackPinkblack fe the resistance within 5.1- 5.8 Cl (20C68F)7 YES NOGO TO STEP 3- Faulty front final clutchFRONT FINAL CLUTCH 2P (GREEN) CONNECTOR (Clutch side of male terminal)