2006 Honda TRX680 Rincon Factory Service Manual, Page 249Get this manual
ALTERNATORSTARTER CLUTCH The cover (stator) is magnetically attracted to the flywheel, be careful not to get anything caught between these parts when installing
Carefully install the alternator coverInstall the ten bolts with four new sealing washers and the clip stay, and tighten them in crisscross pattern in several stepsNOTE: The location for the bolt with sealing washer is marked on the cover (inside of the recoil starter housing)Apply engine oil to the lips of new oil seal, and install it into the alternator cover until it is seated
BOLTSInstall the starter driven pulley, aligning the bosses with the grooves in the crankshaftCoat new O-ring with engine oil and install it onto the pulley boltApply engine oil to the pulley bolt threads and seating surface, and install the bolt