2006-2014 Honda FourTrax ATV TRX250 EX TRX250X Service Manual, Page 348Get this manual
LIGHTSMETERSSWITCHES
GEAR POSITION SWITCH
INSPECTION
Remove the rear fender (page 3-5)Disconnect the gear position switch wire connectorsCheck for continuity between the switch side connector terminal and ground There should be continuity at the Light green wire terminal when the transmission is in neutralThere should be continuity at the Gray wire terminal when the transmission is in reverse
REPLACEMENT
Remove the rear crankcase cover (page 11-4)Remove the wire grommet from the rear crankcase coverRemove the bolt and the gear position switch from the rear crankcase coverApply locking agent to the gear position switch bolt threadsInstall new gear position switch onto the rear crankcase cover and tighten the boltApply sealant to the grommet seating surface and install the grommet into the rear crankcase cover groove securelyInstall the alternator cover (page 11-11)