2006-2014 Honda FourTrax ATV TRX250 EX TRX250X Service Manual, Page 301Get this manual
REAR DRIVING MECHANISM Be sure to wear heavy gloves to avoid burns when handling the heated gear caseUsing torch to heat the gear case may cause warpageRemove the collet from the 75 mm bearing remover and use it on the 74 mm remover shaft
Heat the gear case to 80C (176F) and remove the needle bearing by using the special tool
TOOLS: Bearing remover head, 14 mm 07WMC-KFG0100 Remover shaft, 15 mm 07936-KC10100 Remover weight 07741 -0010201 U.S.ATOOLS: Bearing remover, 15 mm Remover shaft, 14 mm Remover handle Remover weight
07936-KC10500 07YMC-001010A 07936-3710100 07936-371020A or 07936-3710200
Remove the bearing cage and bearings from the inside of the pinion bearing to allow the special tool to grip the bearing Install new stopper ring into the groove in new bearingInstall the bearing into the special tool until the bearing is flush with the end of the toolCOMPRESSOR