2006-2014 Honda FourTrax ATV TRX250 EX TRX250X Service Manual, Page 159Get this manual
CLUTCHGEARSHIFT LINKAGE Turn the crankshaft end bearing inner race with your fingerThe bearing should turn smoothly and quietlyAlso check that the bearing outer race fits tightly in the crankcase coverReplace it if necessary (page 10-8)
BEARING REPLACEMENT
Remove the crankshaft end bearing using the special toolsTOOLS: Bearing remover shaft, 15 mm 07936-KC10100 Bearing remover head, 15 mm 07936-KC10200 Remover weight 07741-0010201
U.S.ATOOLS: Bearing remover, 15 mm Remover weight
07936-KC10500 07936-371020A or 07936-3710200
Drive new bearing into the crankcase cover, with its sealed side facing down, using the special toolsTOOLS: Driver Attachment, 32 35 mm Pilot, 15 mm