2006-2014 Honda FourTrax ATV TRX250 EX TRX250X Service Manual, Page 76Get this manual
MAINTENANCE Measure the toe on the rear part of the tire at th same pointsToe-in means the rear measurement is greater than the front measurement
TOE-IN: 2.3 15 mm (332 916 in)
When the toe is out of specification, adjust it by changing the length of the tie-rods equally by loosening the lock nuts and turning the tie-rods while holding the ball joints
Using 22 mm wren ch, hold the ball joint ends (flats) so that the relative angle of both ball joints is within the specified range as shown Thentighten each lock nut, making sure not to force the ball joint end against the ball joint studTORQUE: 54 Nm (5 .5 kgfm, 40 Ibfft) After tightening the lock nuts, rotate the tie-rods to make sure the ball joints operate properly and have an equal range of movement