2006-2009 Honda TRX680 (TRX 680 FA-FGA) Factory Service Manual, Page 308Get this manual
DRIVETRAIN SYSTEM
DRIVETRAINDTC TROUBLESHOOTING
The connector location and the necessary parts
, to disconnect the connector (page 14-17)
Perform inspection with the ignition switch
turned OFF, unless otherwise specified
After troubleshooting, erase the problem code
and test-ride the vehicle to be sure that the system is normal
DTC 3-1 (FRONT FINAL CLUTCH LOW INPUT)DTC 3-3 (FRONT FINAL CLUTCH DRIVE CIRCUIT)
Before starting the troubleshooting, check for
loose or poor contact on the front final clutch 2P [Green) connector and peM 33P (Black} ccnnec-
tor and then recheck the DTC1Recheck DTe
Turn the ignition switch ON and test-ride the
vehicle with 4WD, then recheck the current DTC
or 3-3 indicated?
- GOTO Sn;P 2- Intermittent failure
2Front Final Clutch Inspection
Turn the ignition switch OFFDisconnect the front final clutch 2P {Green} connectorMeasure the resistance between the front final clutch 2P (Green) connector terminals of the clutch sideFRONT FINAL CLUTCH 2P (GREEN) CONNECT(JR [Clutch side of male terminal)