2006-2009 Honda TRX250EX/TRX250X Service Manual, Page 195Get this manual
AL TERNATORISTARTER CLUTCH ALTERNATOR STATOR Remove the wire grommets from the crankcase coverRemove the three bolts and stator
GRc;mIMETS
INSTALLATION
Install the stator onto the crankcase coverApply sealant to the seating areas of the grommetsRoute the wire properly as shown and install the grommets into the cover groove securelyInstall the three bolts and tighten them
Apply locking agent to the CKP sensor bolt threadsInstall the CKP sensor and tighten the two bolts, being careful not to pinch the wireTORQUE'm (0.61 kgfm 4.4 Ibf.ftl Route the wire through the wire guide and connect the connectorInstall the rear crankcase cover (page 11-11)