2006-2009 Honda TRX250EX/TRX250X Service Manual, Page 187Get this manual
CLUTCHGEARSHIFT LINKAGE Apply locking agent to the ret ainin bolt threadsBe careful no to damage the gear POSition sWitch end CKP sensor on the crankcase
Install the retaining bolt with new sealing washer by aligning it with the spi ndle groove and tighten it
TORQUE: 12 (1.2 kgfm 91bfftj Turn the spindle and check for smooth operationInsta ll the following:rear crankcase cover (page 11 -1 1)change clutch (page 10-22)
REVERSE STOPPER SHAFT
REMOVALIINSPECTION
Remove the fear crank case cover (page 11-4)Raise the stopper plale slightly with screwdriver to release it from the shift drum, then release the crankcase mating spring lower end off of the crankcase and remove surface the revere stopper shaftBe careful not to