2006-2009 Honda TRX250EX/TRX250X Service Manual, Page 174Get this manual
CLUTCHGEARSHIFT LINKAGE Clean the O-ring groove in the drive plate thoroughly and apply grease into the grooveCoat new O-ring with engine oi and nstall it into
the groove
Apply locking agent to the fil er cover boh threadsInstall the oil filter cover and tighten the three boltsInstall the front crankcase cover (page 10-30)
CHANGE CLUTCH
DISASSEMBLY
Remove the centrifugal clutch (page 10-10)
Temporarily install the centrifugal clutch drum by aligning the concavity of the change clutch outer with the primary drive gear of the clutch drumInstall the gear holder between the primary drive and driven gears as shown, and loosen the four clu ch spring bolt in crisscross pattern in several steps