2006-2009 Honda TRX250EX/TRX250X Service Manual, Page 77Get this manual
MAINTENANCE When the toe is out of specification, adjust it by changing the length of the tie-rods equally by loosening the lock nuts and turning the tie-rods while holding the ball joints
Using 22 mm wrench, hold the ball joint ends (flats) so that the relative angle of both ball joints is within the specified range as shownThen, tighten each lock nut, making sure not to force the ball joint end against the ball joint stud TORQUE: 54 'm !5.5 kg fm 40 Ibf.ft) After tightening the lock nuts, rotate the tie-rods to make sure the ball joints operate properly and have an equal range of movement