2005-2011 Honda Recon TRX250TE/TM service manual, Page 311Get this manual
REAR DRIVING MECHANISM To reassemble, fi rst install the pinion spacer NOTEWhen he gear set, pi nion bearing ando gear case has been replaced, use 2.0 mm (0.08 in) thick spacer
Apply #80 gear oil to he bea ing
PiNioNGEAR
Press the bearing onto the drive pinion wi th its groove side facing Qut using the special tools as shownTOOLS:
Driver, 40 mm I.DAttachment, 30 mm .0
07746-0030100 07746-0030300
ATTACHM ENT, 30 LD
PINION NEEDLE BEARING REPLACEMENT
Remove the stopper ring by rot ating it until the end of the stopper ring appears in the access holeBend up the end of the ring wit screwdriverGrasp the end of the ring with needle-nose pliers and pu ll the stopper ring out through the access holeRemove the iller cap