2005-2011 Honda FourTrax Foreman TRX500 FE/FPE/FM/FPM/TM Service Manual, Page 277Get this manual
FRONT WHEELSUSPENSIONSTEERING Once the tool is in place, turn the adjusting bolt as necessary to make the jaws parallelThen hand-tighten the pressure bolt and recheck the jaws to make sure they are still parallelTighten the pressure bolt with wrench until the ball joint stud pops oosePRESSURE BOLT
Remove the ball joint nuts and the knuckle from the upper and lower arms
ADJUSTING BOLT
INSPECTION
Turn the inner race of each bearing in the wheel hub (TM modeland knuckle (Except TM model) with your fingerThe bearings should turn smoothly and quietlyAlso check hat the bearing outer race fits tightly in the hub or knuckleInspect the knuckle for damage or cracksInspect the ball joint boot for tears or other damage by moving the ball joint studIt should move freely and smoothly