2005-2008 Honda ATV TRX500FA/FGA Fourtrax, Rubicon Factory Service Manual, Page 283Get this manual
FRONT WHEELSUSPENSIONSTEERING Trim the plug mm (14 in) above the tire surfaceRepeat the above procedure if the puncture is largeDo not use more than two plugs per injuryAllow the repair to dryDrying time will vary with air temperatureRefer to the tire repair kit manufacturers recommendations
Inflate the tire and test the seal by dabbing small amount of cement around the plugEscaping air will cause bubble in the cementIf there is leakage, remove the tire (page 14-13) and apply cold patch to the inside of the tire as describedIf plug has been inserted, trim it even with the inner tire surfaceTemporarily place rubber patch that is at least twice the size of the puncture over the injuryMake mark around the patch, slightly larger than the patch itselfRough the area marked inside the tire with tire buffer or wire brushClean the rubber dust from the buffed areaApply cement over the area marked and allow it to dry until tackyDo not touch the cement with dirty or greasy handsRemove the lining from the patch and center over the injuryPress the patch against the injury using special roller