2005-2008 Honda ATV TRX500FA/FGA Fourtrax, Rubicon Factory Service Manual, Page 278Get this manual
FRONT WHEELSUSPENSIONSTEERING Install the handlebar switch and loosely tighten the three screwsHANDLEBAR SWITCH
SCREWS Install the brake lever bracket and holder with the punch mark facing up by aligning the locating pin on the lever bracket with the hole in the handlebar switch housingLoosely tighten the bracket holder screwsAlign the edge of the brake lever bracket with the punch mark on the handlebar, and tighten the upper bracket screw first, then tighten the lower screwTighten the upper handlebar switch screw first, then tighten the lower screwsLEVER BRACKET PUNCH MARK SCREWS
PIN AND HOLE Install the front brake master cylinder and holder with the "UP" mark facing upAlign the edge of the master cylinder with the punch mark on the handlebar, and tighten the upper bolt first, then tighten the lower boltTORQUE: 12 Nm (1.2 kgfm, lbfft) Connect the brake light switch connectors