2005-2006 Honda ATV TRX500FE/FM/TM FourTrax Foreman Factory Service Manual, Page 336Get this manual
REAR DRIVING MECHANISM BRAKE PANEL Remove the snap ringDrive the axle bearings out of the brake panel
Support the bearing housing section of the brake panel when installing,
Drive the outer bearing (brake drum side) squarely with the sealed side facing down until it is fully seated, then the inner bearing with the sealed side facing upTOOLS: Driver Oil seal driver attachment Pilot 28 mm 07749-0010000 07JAD-PH80100 07746-0041100
ATTACHMENT Install the snap ring with the chamfered side facing to the bearing securelyApply grease to new dust seal lipsInstall the dust seal with the flat side facing up until it is flush with the brake panelSNAP RING