2000-2003 Honda TRX350 Rancher factory service manual, Page 281Get this manual
REAR DRIVING MECHANISM Be sure to wear heavy gloves to avoid burns when handling the heated case coverUsing torch to heat the case cover may cause warpage
Remove the ring gearIf the clearance exceeds the standard value, heat the case cover to approximately 80C (176F) and remove the stop pin by tapping the coverInstall stop pin shim to obtain the correct clearanceStop pin shims: A: 0.10 mm (0.004 in) B: 0.15 mm (0.006 in) Install the shim and drive the stop pin into the case cover
STOP PIN
FINAL GEAR CASE ASSEMBLY
When the gear set, bearing, andor gear case has been replaced, check the tooth contact pattern check (page 16-8) and gear backlash (page 16-6)K eep dust and dirt out of the case and cover