2000-2003 Honda TRX350 Rancher factory service manual, Page 278Get this manual
REAR DRIVING MECHANISM Apply grease to new oil seal lipsInstall each oil seal with the flat side facing out until it is flush with the case or coverTOOL: Driver Attachment, 52 OIL SEALS
07749-0010000 07746-0010400
PINION NEEDLE BEARING
Remove the stopper ring by rotating it until the end of the stopper ring appears in the access holeBend up the end of the ring with screwdriverGrasp the end of the ring with needle-nose pliers and pull the stopper ring out through the access holeRemove the filler capBe sure to wear Heat the gear case to 80 (176 F) and remove the heavy gloves to needle bearing by using the special toolsavoid burns when handling the heated gear caseUsing torch to heat the gear case may cause warpage
BEARING
TOOL: Bearing remover, 14 mm Remover shaft, 15 mm Remover weight U.S.Aonly: Bearing remover, 15 mm Remover shaft, 14 mm Remover weight Remover handle
07WMC-KFG0100 07936-KC10100 07741-0010201 STOPPER RING 07936-KC10200 07YMC-001010A 07936-371020A or 07936-3710200 07936-3710100