2000-2003 Honda TRX350 Rancher factory service manual, Page 271Get this manual
REAR DRIVING MECHANISM BRAKE PANEL Remove the snap ringDrive the axle bearings out of the brake panelSupport the bearing housing section of the brake panel when installing
Drive the outer bearing (brake drum side) squarely with the sealed side facing down until it is fully seated, then the inner bearing with the sealed side facing upTOOLS: Driver Attachment, 52 Pilot, 28 mm
DRIVER ATTACHMENT
07749-0010000 07746-0010400 07746-0041100
Install the snap ring with the chamfered side facing to the bearing securelyApply grease to new dust seal lipsInstall the dust seal with the flat side facing up until it is flush with the brake panel