2000-2003 Honda TRX350 Rancher factory service manual, Page 270Get this manual
REAR DRIVING MECHANISM INSPECTION Set the axle in V-blocks and measure the axle runout with dial indicatorAxle runout is 12 the total indicator readingSERVICE LIMIT: 3.0 mm (0.12 in)
AXLE BEARING Remove the dust seals from the axle housing and brake panelTurn the inner race of each bearing with your fingerThe bearings should turn smoothly and quietlyAlso check that the bearing outer race fits tightly in the housing or panel
BEARINGS
DUST SEALS
BEARING REPLACEMENT
AXLE HOUSING Drive the axle bearing out of the axle housingPress the bearing into the axle housing with the sealed side facing down until the depth from the housing edge is 11.0 mm (0.43 in)TOOLS: Driver Attachment, 52 55 mm Pilot, 32 35 mm DRIVER