2000-2003 Honda TRX350 Rancher factory service manual, Page 258Get this manual
FRONT DRIVING MECHANISM (FMFE models) Drive the bearings into the case and coverTOOLS: Driver Attachment, 52 Pilot, 28 mm
07749-0010000 07746-0010400 07746-0041100
ATTACHMENT AND PILOT
Apply grease to new dust seal lips and install them into the case and coverTOOL: Attachment, 20 mm I.DATTACHMENT
07746-0020400
PINION NEEDLE BEARING
Remove the stopper ring by rotating it until the end of the stopper ring appears in the access holeBend up the end of the ring with screwdriverGrasp the end of the ring with needle-nose pliers and pull the stopper ring out through the access holeRemove the filler capBe sure to wear Heat the gear case to 80 (176 F) and remove the heavy gloves to needle bearing by using the special toolsavoid burns when handling the heated gear caseUsing torch to heat the gear case may cause warpage
BEARING