2000-2003 Honda TRX350 Rancher factory service manual, Page 199Get this manual
FRONT WHEELSUSPENSIONSTEERING Apply grease to new outer dust seal lips and install it using the same tools until it is flush with the knuckle endOUTER DUST SEAL
Apply grease to new inner dust seal lips and install it until it is fully seated being careful not to damage the lipsTOOLS: Driver Oil seal driver
07749-0010000 07JAD-PH80101
OIL SEAL DRIVER
INNER DUST SEAL
INSTALLATION
Install the knuckle onto the drive shaft (FMFE only) and the lower and upper arms with the joint nutsConnect the tie-rod into the knuckle with new joint nutTighten each arm joint nut to the specified torque and further tighten until their grooves align with the cotter pin holeTORQUE: 29 Nm (3.0 kgfm22 lbfft) Tighten the tie-rod joint nutTORQUE: 54 Nm (5.5 kgfm40 lbfft) Install new cotter pinsCoat new O-ring with grease and install it onto the knuckle