2000-2003 Honda TRX350 Rancher factory service manual, Page 3Get this manual
1GENERAL INFORMATION SERVICE RULES MODEL IDENTIFICATION SPECIFICATIONS TORQUE VALUES TOOLS 1-1 1-1 1-3 1-13 1-16 LUBRICATIONSEAL POINTS CABLEHARNESS ROUTING EMISSION CONTROL SYSTEMS EMISSION CONTROL INFORMATION LABEL (U.S.A only) 1-18 1-22 1-33 1-34
SERVICE RULES
1Use genuine HONDA or HONDA-recommended parts and lubricants or their equivalentsParts that don't meet HONDA's design specifications may cause damage to the motorcycle2Use the special tools designed for this product to avoid damage and incorrect assembly3Use only metric tools when servicing the motorcycleMetric bolts, nuts and screws are not interchangeable with English fasteners4Install new gaskets, O-rings, cotter pins, and lock plates when reassembling5When tightening bolts or nuts, begin with the larger diameter or inner bolt firstThen tighten to the specified torque diagonally in incremental steps unless particular sequence is specified6Clean parts in cleaning solvent upon disassemblyLubricate any sliding surfaces before reassembly7After reassembly, check all parts for proper installation and operation8Route all electrical wires as shown on pages 1-22 through 1-32, CableHarness routing