1999-2004 Honda TRX400EX FourTrax Service Manual, Page 195Get this manual
REAR WHEELSUSPENSION Press the marking side the bearing
Apply grease to new needle bearing rollersCarefully press the needle bearing and thrust bushing into the swingarm pivot until the bushing is fully seated
NEEDLE BEARING?RFhflnFR
TOOL Needle bearing remover
07946KA50000
SHlNG RING
Pack grease into new inner dust seal lip cavitiesInstall the inner dust seals until they are flush with the pivot surfacesInstall the pivot collars
INSTALLATION
Install the following if they are removed: -under cover with the bolt -chain slider with the bolts and collars Pack grease into new outer dust seal lip cavitiesInstall the outer dust seals onto the swingarm pivots and the seal caps over the dust seal securelySet the swingarm into the frame, take care to prevent removing the dust seal caps, and install the pivot bolt from the right sideInstall the pivot nut and tighten it