1999-2004 Honda TRX400EX FourTrax Service Manual, Page 171Get this manual
FRONT WHEELISUSPENSIONISTEERING Apply cement over the area marked and allow it to dryRemove the lining from the patch and center it over the injuryPress the patch against the injury using special rolIe rNOTE:
Allow cement to dry until tacky before applying patchDo not touch the cement with dirty or greasy hands
ASSEMBLY
Install the tire onto the rim, where the rim shoulder width is the narrowest, to simplify installationClean the rim bead seat and flangesApply clean water to the rim flanges, bead seat and base
Use only water as lubricant removing or mounting tiresSoap or some mounting lubricants may leave slippery residue which cause the tire to shift on the rim and lose air pressure during ridingInstall the valve core in the valve stemInstall the front tire with the arrow mark facing in the normal rotating directionInstall the rear tire with the "OUT SIDE" facing the tire valveInflate the tire to seat the tire beadDeflate the tireWait hour and inflate the tire to the specified pressureCheck for air leaks and install the valve capCOLD TIRE PRESSURE lFrontRear): Standard: 27 kPa 10.275 kgflcm', 4.0 psi) Minimum: 23 kPa 10.235 kciflcmz3.4 osil Maximum: 31 kPa 10.315 kgflcmz, 4.6psil FRONT TIRE: LEFT