1998-2004 Honda Foreman 450 factory service manual, Page 358Get this manual
REAR DRIVING MECHANISM
8 mm BOLT: 25 N'm (2.6 kgf'm, 19 Ibfft) 10 mm BOLT: 49 N'm (5.0 kgf'm, 36 Ibfft)
10 mm BOLT:
108 N'm (1 1.0 kgf'm, 80 Ibfft)
NOTE: When the bearing, gear set andor gear case has been replaced, check the tooth contact pattern (page16-9) and gear backlash (page 16-7)Keep dust and dirt oul of the gear case
Install the ring gear spacers onto the ring gearInstall the ring gear, with the spacers, into the final drive caseApply liquid sealant to the mating surface of the gear case coverApplya locking agent to the threads of the 10 mm bolts Tighten the cover bolts in two or three steps until the cover even Iy touches the gear caseI)1rTl BOL-r:? Then, wh le rotating the drive pinion, tighten the bolts to the specified torque in two or three steps in crisscross pattern TORQUE: 10 mm bolt: 49 N'm (5.0 kgfm, 36 Ibf.ft) mm bolt: 25 Nm (2.6 kgfm, 19 Ibfoft) CAUTION: