1998-2004 Honda Foreman 450 factory service manual, Page 329Get this manual
FRONT DRIVING MECHANISM Install the stopper ring into the groove in the bearingInstall the bearing into the compressor until the bearing is flush with the end of the toolPlace the driver on top of the bearing and tape the driver to the compressorPlace the assembly into freezer for at least 30 minutesTOOLS: Driver Differential bearing ring compressor '98- '01Attachment, 24 26 mm After '01Attachment, 22 24 mm After '01Pilot, 14 mm Heat the gear case to
COMPRESSOR
BEARING
077 49-00 10000 07VME-HN4010A 07746-0010700 077 46-0010800 07746-0041200
aoc (176F)
Remove the needle bearing .and tool assembly from the freezer and drive the bearing into the gear case using the special tools Only strike the driver onceIf you strike it more than once, the ring may slip out of the grooveIf this happens, remove the ring and bearingand install new one