1998-2004 Honda Foreman 450 factory service manual, Page 328Get this manual
FRONT DRIVING MECHANISM Drive the ring gear bearing into the case and cover using the special toolsTOOLS: Driver Attachment, 52 55 mm Pilot, 28 mm (After '01)
07749-0010000 077460010400 077 46-0041100
Install new oil seals in the case and cover using the special toolsTOOL (After '01): Driver Attachment,52 55 mm
07749-0010000 077 46-00 10400
Apply grease to the oil seal lips
PINION NEEDLE BEARING REPLACEMENT
Remove the stopper ring by rotating it until the end of the stopper ring appears in the access holeBend up the end of the ring with screwdriverGrasp the end of the ring with needle-nosed pliersand pull the stopper ring out through the access STOPPER RING ho leHeat the gear case to BO' (176F) and remove the pinion needle bearing by using the special toolTOOLS: Bearing remover, 14 mm Remover shaft, 15 mm Remover weight USA only: Bearing remover, 15 mm Remover shaft, 14 mm Remover weight Remove handle