1998-2004 Honda Foreman 450 factory service manual, Page 149Get this manual
CYLINDE HEAD CYLINDERPISTON ROCKER ARM HOLDER INSTALLATION Properly install the push rods into the center groove of the cam followerNOTE: If reusing, install the push rods in their originallocations as markedInstall the two dowel pins
Turn the crankshaft clockwise using the recoil starter knob, and align the "T" mark on the flywheel with the index mark on the rear crankcase coverMake sure the piston is at TDC on the compression strokeIf not, rotate the crankshaft 360 (1 full turn) and align the "T" mark with the index markInstall the rocker arm holder onto the cyli nder headInstall the new washers and cap nutsTighten the cap nut in crisscross pattern instepsTORQUE: 39 N'm (4.0 kgfm, 29 Ibfoft) Install and tighten the cylinder head mounting mm boltsInstall the upper engine hanger brapket, and tighten bracket bolts and the hanger boltTORQUE: Bracket bolt: Hanger bolt: