1997-2004 Honda Fourtrax Recon TRX250TE/TM Service Manual, Page 244Get this manual
REAR WHEELSUSPENSION Position the swingarm in the frame by aligning the spline between the final drive shah and yoke joint
YOKE JOINT DRIVE SHAFT
Install and tighten the right pivot bott using commercially available toot as shown
TORQUE: 113 Nm (1 1.5 kgfm83Ibfh)
Install and tighten the left pivot bolt using commercially available toolTORQUE: Nm (0,4 kgfm, 2.9Ibfft)
LOCK NUT WRENCH
Move the swingar up and down several timesRetighten the left pivot bolt to the specified torque (see above), Tighten the right pivot lock nut while holding the pivot bolt using the special tools as shownTORQUE: 113 Nm (1 15 kgfm ,83 Ibfft)