1997-2001 Honda TRX250 Fourtrax Recon Service Manual, Page 117Get this manual
CYLINDER HEADCYLINDERPISTON
ROCKER ARM HOLDER INSTALLATION
Properly install the push rods into the center groove of the cam follower NOTE :
If reusing, install the push rods in their origina locations as marked CAM
FOLLOWER
Install the two dowel pins
Insta ll the rocker arm hol der onto the cylinder headInstall th new washers and cap nutsInstal the flange bolt (8 mm)Tighten the cap nut and flange bolt (8 m), in crisscross pattern insteps