1993-2000 Honda TRX300EX Service Manual, Page 137Get this manual
Rear WhoeUSuspension AxJe Lock Nut Loosening Loosen the axle inner lock nut while holding the outer lock nut(1) LOCK NUT WRENCH, 56 mm
NOTE: The inner lock nut has left-hand threads
Lock nut wrench, 56 mm
07916HA20000 or 07918- HA2010A
(U.S.AOnly)
Lock nut wrench45 mm
079181870101 or
equivalent commerclalV available In U.SA
Loosen the outer lOck nut by turning it counterclockwise until the stopper ring comes out enough to be removedNOTE:
(11 LOCK NUT WRENCH, 45 mm
I The outer lock nut has left-hand threadsLock nut wrench, 45 mm
079161870101 or
equivalent commerclaHy available in U.S A
Remove the stop ring, outer lock nut and inner lock nut from the axle
Axle Lock Nut Tightening
Install the axle nut over the axle shaftApply locking agent to the threads of the inner lock nut InstaN the inner lock nut, outer lock nut and screw them on counterclockwise until the stop ring groove in the axle shaft comes outInstan the stop ring into grooveScrew the outer lock nut clockwise until it seats against the stop ring and tighten the lock nutLock nut wrench45 mm