1987 Honda Fourtrax TRX 250X Service Manual, Page 205Get this manual
HYDRAULIC BRAKES Install the brake lever onto the master cylinder and tighten the pivot bolt and nutTORQUE:12 Nm 10.81.2 kg-m6ft-Ibl Install the rubber cover
(ll COVER
INSTAllATION
Place the front brake master cylinder on the handlebar and install its holder with the "UP" mark facing upAlign the end of the holder with the punch mark on the handlebar and tighten the upper screw first, then tighten the lower (31 PIVOT NUT
screw(11 Align the lower edge of the throttle housing with the punch mark on the handlebar and tighten the forward screw first, then tighten the fe8r screwConnect the brake hose to the master cylinder using the oil bolt and two sealing washers 50 the hose joint neck is positioned in the stoppers on the master cylinder bodyMake sure that the oil bolt sealing washers are in good conditionTighten the oil boltTORQUE: 2535 Nm 12.5 -35 kgm, 1825 ftlbl Fill and bleed the front hydraulic systam (page 143)(4 "UP" MARK BOLT (21 SEALING