1986-1987 Honda TRX350 FourTrax 4X4, 1987-1989 TRX350D Foreman 4X4 Service Manual, Page 168Get this manual
FRONT WHEELSUSPENSIONSTEERING With the breaker arm in the horizontal position, place the breaker press head assembly over the breaker arm press blockMake sure he press head bolt is backed out all the way and then pos ition the nylon buttons on the press head aga inst the inside edge of the rim Insert the threaded shaft through the appropriate hole in the breaker press head assembly and then tighten the lever nut until both ends of the breaker press head assembly are in firm contact with he rimTight en the press head bolt until the reference mark on the press block is aligned with the top edge of the press head(5) PRESS HEAD ASSEMBLY
If the rest of the bead cannot be pushed down into the center of the rim by hand, loosen the press head bolt and the lever nutRotate the breaker arm assembly and breaker press head assembly 1 to 14 the circumference of the rim Tighten the lever nut and then tighten the press head bolt as described Repeat this procedure as necessary until the rema inder of the bead can be pushed down into the center of the rim Assemble the Universal Bead Breaker on the other side of the wheel and break the bead following the same proceduresRemove the tire from the rim using ire changer machine or ire irons and rim protectorsRemove tire from rim that has the smallest shoulder area to simplify removal