1983-1985 Original Honda ATC 200X Shop Manual, Page 170Get this manual
REAR SUSPENSION DRIVER 07749-0010000
Drive in the axle shaft ball bearingSlide the collar into the swingarm from the opposite sideDrive in the ball bearing on the opposite sideInstall the dust seals
PI LOT, 35 mm 07746-0040800
ATTACHMENT, 62 68 mm
07746-0010500
Grease the pivot needle bearingsDrive in the swingarm pivot needle bearing until the attachment contacts the swingramNOTE:
07749-0010000
ATTACHMENT, 32 35 mm
mark should face out
077 46-0010100
Align the thrust bushing with the installed needle bearingDrive in the thrust bushing with the same special tools until the bushing shoulder comes in contact with the swingarmRepeat this procedure for the opposite side