1983-1985 Original Honda ATC 200X Shop Manual, Page 12Get this manual
GENERAL INFORMATION
Note the following when routing cables and wire harnessesA loose wire, harness or cable can be safety hazardAfter clamping, check each wire to be sure it is secu reo Do not squeeze wires against the weld or end of its clamp when weld-on clamp is usedSecure wires and wire harnesses to the frame with their respective wire bands at the designated locationsTighten the bands so that only the insulated surfaces contact the wires or wire harnessesRoute harnesses so they are not pu lied that or have excessive slackProtect wires and harnesses with electrical tape or tube if they are contact sharp edge or cornerClean the attaching surface thoroughly before applying tapeDo not use wires or harnesses with broken insulatorRepair by wrapping them with protective tape or replace themRoute wire harnesses to avoid sharp edges or cornersAlso avoid screwsthe projected ends of bolts and