2006 Bombardier Outlander Max Series Factory Service Manual, Page 442Get this manual
Section 12 BODYFRAME Subsection 02
GENERAL
During assemblyinstallation, use the torque va lues and service products as in the exploded viewsClean threads before applying thread lockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure
Rear Footrest Support To remove the rear footrest support no5, use same procedure than front footrest support but remove bolts no6 instead of bolts no2Passenger Footrest Support All MAXMAX XT Models Remove both footrestsUnscrew bolts no7 then remove passenger footrest support(s) no8&
WARNING
Torque wrench tightening specifications must strictly be adhered to Locking devices (e.g locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed CAUTION: Before performing electrical welding anywhere on the vehicle, unplug the electronic module connectorAlso unplug the negative cable and the voltage regulatorThis will protect the electronic module and battery against damage caused by flowing current when welding