2006 Bombardier Outlander Max Series Factory Service Manual, Page 396Get this manual
Section 10 SUSPENSION Subsection 02 (REAR SUSPENSION)
GENERAL
The procedure described below is the same for the RH and LH sides, unless otherwise instructed, During assemblyinstallation, use the torque values and service products as in the exploded Views, Clean threads before applying threadlocker, Refer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure ,
WARNING
CAUTION: Always use the recommended wheel nutsUsing different nut could cause damages to the rim
Torque wrench tightening specifications must strictly be adhered toLocking devices (e .g locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specified If the efficiency of locking device is impaired, it must be renewed
REAR SHOCK
Removal
Lift rear of vehicle until rear shock absorbers no1 are fully extended Install jack stands or blocks under the frame to support the vehicle, Remove upper no2 and lower no3 bolts retaining shock absorbers,