2006 Bombardier Outlander Max Series Factory Service Manual, Page 393Get this manual
Section 10 SUSPENSION Subsection 01 (FRONT SUSPENSION)
Remove upper suspension arm from vehicle
Removal
Remove upper suspension armRemove the circiip no27
Installation
Position the upper suspension arm and install its bolts no17Torque to 61 N-m (45Ibf-ft)Attach the upper suspension arm to knuckleWhen hardened washer no19 and upper ball joint nut no15 are installed, tighten nut to 45 N-m (33 Ibf-ft) and further tighten until one of its grooves is aligned with cotter pin holeInstall new cotter pinBoth end of cotter pin must be foldedInstall the shock absorber lower bolt and torque it to 48 N-m (35 Ibf-ft) Install wheel
UPPER SUSPENSION ARM BRACKET
Outlander 800 Series Only
Using press and piece of pipe, remove the ball jointCAUTIO"I: Support upper suspension arm properly to avoid damaging ball joint location
Removal
Remove both front wheelsUnscrew the left caliper and attach it out of wayUnscrew upper suspension arms from their bracket no18Remove upper differential boltsRemove front bolts that attach the upper suspension arm bracket to frameSlide bracket backward then pull it by the left side