2006 Bombardier Outlander Max Series Factory Service Manual, Page 388Get this manual
Section 10 SUSPENSION Subsection 01 (FRONT SUSPENSION)
GENERAL
The procedure explained below is the same for the RH and LH sides unless otherwise noted, During assemblyinstallation, use the torque values and service products as in the exploded viewClean threads before applying threadlocker, Refer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure,
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (e.g locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed
CAUTION: Always use the recommended wheel nutsUsing different nut could cause damages to the rim
SHOCK ABSORBER AND SPRING
Removal
Outlander 400 Series
PROCEDURES TIRES AND WHEELS
Loosen wheel nutsLift front of vehicle until front struts no1 are fully extended then install Jack stand under the frame to support the vehicle off the ground, Remove:appropriate wheelfront rack and cap on the top of the front fenderbolts no2 retaining strut to the knuckle