2006 Bombardier Outlander Max Series Factory Service Manual, Page 380Get this manual
Section 09 STEERING SYSTEM Subsection 01 (STEERING SYSTEM)
NOTE: First, check if ball joint is looseIf necessary repair all defective parts before checking the wheel bearing condition Be careful not to misjudge loose in the ball joint and loose in the wheel bearing
WARNING
Clean all grease, outside and inside, from knuckle before heating it
Removal
Remove:knuckle from vehicle, (see above)seal (discard)
Installation
Place the bearing in freezer for 10 minutes before installing Place the knuckle in oven to 100 (212F) for 30 minutes maximum to ease bearing installationWhen knuckle is cold, install the circlip and the new sealInstall the other parts in the reverse order of removal procedure