2006 Bombardier Outlander Max Series Factory Service Manual, Page 378Get this manual
Section 09 STEERING SYSTEM Subsection 01 (STEERING SYSTEM)
NOTE: Use the same procedure for RH and LH side
KNUCKLE
Removal
Outlander 400 Series
Place vehicle on jack stands and remove the appropriate wheelSepa rate ti e-rod no13 from knuckle
Removal
Place the vehicle on jack stands and remove the appropriate wheelRemove cotter pin (discard it), elastic nut and hardened wa shers
VQ710PA
1Cotter pin 2Elas tic nut 3Hardened wash ers
TYPICAL
Inspection
Inspect ball Joint ends for wear or looseness, if excessive, replace
Remove- wheel hub (refer to FRONT DRIVE!bolt retaining the low er ball Joint the knuckle