2006 Bombardier Outlander Max Series Factory Service Manual, Page 377Get this manual
Section 09 STEERING SYSTEM Subsection 01 (STEERING SYSTEM)
Inspection
Inspect steering column for wear, cracks or bending, replace if any of these problems is detectedCheck if O-rings no 18 are brittle, hard or otherwise damagedReplace if necessaryAt the same time, check steering bearing condition It must turn smoothly and freelyIf not, refer to STEERING COLUMN BEARING for replacement procedure
Remove cotter pin no19 (d iscard it), elastic nut no20 and flat washer no21 to bottom end of steering column no12
Insta IIation
For the installation, reverse the removal procedure Pay attention to the following Apply synthetic grease (PIN 529 550 010) on O-rings and on bushings Install new cotter pinBoth ends of cotter pi must be folded Pull up steering column
STEERING COLUMN BEARING