2006 Bombardier Outlander Max Series Factory Service Manual, Page 364Get this manual
Section 08 DRIVETRAIN Subsection 03 (REAR DRIVE)
V07H1SA
- elastic nut
1Wheel hub 2Wear ring
Installation
The installation is the reverse of removal procedurePay attention to the following Apply XP-S synthetic grease (PIN 293550010) on drive sha ft splinesInstall Belleville washer no4 in correct orientationInside diameter must protrude outwardTorque castellated nut to 205 N-m (151 Ibf-ft) and further tighten until one of its grooves is aligned with cotter pin hole Install new cotter pinFold one Pin of cotter pin over drive shaft end
- washertorsion bar lever
DIFFERENTIAL PROTECTOR
Removal