2006 Bombardier Outlander Max Series Factory Service Manual, Page 359Get this manual
Section 08 DRIVETRAIN Subsection 02 (FRONT DRIVE)
Remove LH drive shaftUnscrew lower and upper differential boltsRemove them and move the differential forwardsRemove front propeller shaft no11
Support U-Joint in vice and drive inner yoke down to remove remaining bearing capsRemove U-joint cross
Installation
Install new U-joint cross in inner yokeInstall new bearing cap by handNOTE: Carefully install U-joint cross with grease fitting properly positioned
Inspection
Check:splines for wear or damageif U-joint moves freely in all directionbellows for holes or brittleness