2006 Bombardier Outlander Max Series Factory Service Manual, Page 358Get this manual
Section 08 DRIVETRAIN Subsection 02 (FRONT DRIVE)
- RH drive shaftboth Oetiker clamps (discard them)
TYPICAL
If the drag torque is greater than 0.7 N-m (6 Ibf-in), reduce preload shim by 0.05 mm (.002 in) and check drag torque againIf the drag torque is less than 0.06 N-m (.5Ibf-in), increase preload shim by 0.05 mm (.002 in) and check drag torque again
V07 HOIA
1Remove these clamps
- differential mounting boltsPull differential no3 back then separate propeller shaft no11 from differential and disconnect unitOutlander 800 Series
Assembly