2006 Bombardier Outlander Max Series Factory Service Manual, Page 357Get this manual
Section 08 DRIVETRAIN Subsection 02 (FRONT DRIVE)
vm r2006-02 3-009_a
1Ba cklash side
2Pre load side
Assemble the differential and check backlash as well as preloadBacklashUsing dial indicator and the backlash measurement tool (PIN 529 035 6651measure the backlashPlace the backlash measurement tool at the end of pinion gear- From center of bolt, measure 25 .4 mm (1 in) and scribe mark on the tab
- Rotate pinion gear 12 turn and check backlash againNote the result- Rotate pinion gear turn and check backlash againIf backlash is below 0.05 mm (.002 in), increase backlash shim by 0.05 mm (.002 in) and check the backlash again If backlash is greater than .356 mm (.014 in), decrease backlash shim by 0.05 mm (.002 in) and check the backlash again Measure preloadPreload Screw the propeller shaft adaptor bolt no12 in pinion gear